Webshop Digisellers Philips Marantz laserunits

CDM12.1 loopwerk Philips

Art.nr.: 372975

BIJ INBOUWPROBLEMEN ook Clamper 2772766 + 2772767 vervangen !

Prijs: €33.00

Aantal:

CDM 12.3 laser + loopwerk compleet

Art.nr.: 2106490

Prijs: €30.00

Aantal:

CDM12.4 Philips CD loopwerk

Art.nr.: CDM12.4

Nieuw in doos

Prijs: €24.00

Aantal:

CDM 12.4 pick-up head Philips CD

Art.nr.: CDM12.4HEAD

Losse kop voor de CDM12.4 laserunit.
Komt o.a. voor in Philips CDI spelers en CD recorders.

Prijs: €22.00

Aantal:

CDM 12.6 CD-Loopwerk

Art.nr.: 1527938

Prijs: €39.00

Aantal:

Philips CD mechanisme DA11N, 3103.309.05290

Philips CD mechanisme DA11N, 3103.309.05290

Art.nr.: 4604629

Laserunit wordt met tinbrug geleverd

Prijs: €65.00

Aantal:

RCD122 loopwerk RCD1.2/2, 482269120931

RCD122 loopwerk RCD1.2/2, 482269120931

Art.nr.: 790477

Soms is een service-manual nodig voor het inbouwen!

RCD1.2D DISC DRIVE - service hint
Service hint to detect a bad disc drive.
SYMPTOM: One of the following complaint descriptions:
- no function, does not start
- plays badly
- skips tracks
- very shock sensitive
General observation by investigation : HF-signal too small (compared to value: 800 mVpp)
CAUSE: Possible caused by mechanical x/y-fixation of the diode array on the optical pick-up
unit has drifted.
Attention: The laser control of the RCD1.2D disc drive is located on the optical pick-up unit.
The laser current has been adjusted in the production line and is n o t intended to be varied
for service purposes.
If the HF-signal is detected considerably smaller than 800 mVpp, check first as follows:
Play a disc. Turn the FOCUS OFFSET potmeter and observe the HF-signal:
- If the HF-signal decreases in both directions, the x/y-adjustment of the diode array can be
considered to be o.k.
- If the HF-signal increases in one direction, adjust to max. HF and check the FOCUS
OFFSET voltage:
FOCUS OFFSET <+/-100mV this means: x/y-adjustment of diode array is within tolerance.
Conclusion: If above described results are detected, the reason for too small HF-signal might
be a "dying" laser diode or any other fault in the electronic circuit. In case of dying laser diode
the optical pick-up unit (4822 691 30327) has to be exchanged.
FOCUS OFFSET > +/-100mV this means: x/y-adjustment of diode array has drifted and is out
of tolerance
Conclusion: In this case the optical pick-up unit has to be exchanged by a new one (4822 691
30327).
REMARKS: On the service information of concerning typenumber the drawing with the
mechanical instruction how to exchange the optical pick-up unit has been shown. After
replacement of the optical pick-up unit the mentioned electrical adjustments in the service
manual have to be carried out. This publication will be followed by a service information of
each model/typenumber.

Prijs: €69.00

Aantal:

RCD122 Philips lasereenheid

Art.nr.: 1530518

Prijs: €40.00

Aantal:

SFP101N laserunit 15 pins

Art.nr.: 5259310

kan min of meer DA11N vervangen

Prijs: €18.00

Aantal:

Philips Marantz CD laserunit 1202/123V

Art.nr.: VAM1202

Laserunit VAM1202
Opvolger van: VAM1201 and CDM12.1

Let op:
401.11709:
clamper voor gebruik met een CD loader (normaal)

401.11708
clamper voor gebruik met een CD caroussel (3-disc wisselaar)

voor de 7-disc wisselaar wordt het CD-mecha CDM12.1/T (=691.30343) aanbevolen

Prijs: €19.00

Aantal:

Philips VAM1202 laserunit

Art.nr.: 3842280

Verwijder aanwezige soldeerbrug.
Beschadiging door statische lading vermijden en een test doorvoeren.

Prijs: €22.00

Aantal: